B31 Clutch Pushrod

[BeenyBoy]

B31 Plunger with M series gearbox

Should there be a ball at the adjuster end of the clutch push rod. ?

According to service sheet 310 there should, but it is not listed on the Draganfly schematic parts list.

I dont remember seeing one when I stripped it down although there does look like a dimple in one end of the rod..

[elevensies]

hi,
i think theres a ball bearing inside the actuator arm that pushes against the pushrod, its captive so possibly wont show on the schematic as its part of the arm? you might not be able to see it unless you have the casing off

[Pete C]

I think this should show what you are looking for

[ducati2242]

Think it depends on the year . later ones are as Elevensies says . Captivated in the actuator . But you will soon know if it isn't long enough when you refit it then there a ball missing .

[BeenyBoy]

Thanks guys-