Bantam D7 rev changes

Started by lowbandit, 22 Aug, 2018, 15:49

Previous topic - Next topic

lowbandit

Hi folks, I have just bought Bantam D7. Haven't been on one of these since I was a teenager. Thing is when I start her up ticks over nicely but if I turn steering, to right it over revs. Any ideas whats happening? Thought it was throttle cable as it was kinked but fitted new cable and still same  ???

JulianS

Probably the throttle cable, make sure it has a good smooth run and check that it does not tighten when you move the forks to the right. Watch where the cable goes into the twist grip when you turn it to the right. Sometimes you need to move the twist grip position round a bit to get a better cable run. Sometimes slackening the cable adjuster helps.

A10 JWO

If you take the throttle off the handle bars, start it up and move the throttle about you will see what movement is causing it. Regards.

lowbandit

Thank you both. Will try your suggestions in the morning. will post results. Thanks again. :)