Thread cleaning

Started by Tigerfeet, 27 Oct, 2026, 17:58

Previous topic - Next topic

limeyrob

I now have sets of BSF, BSW, BSC, NF and UNC taps and dies.  All cheap off e-bay, but its the only way I can be sure of identifying a thread and even then there are bear traps like 1/2 x 20 CEI and 1/2 x 20 UNF.

iansoady

I still don't think there are appreciable differences between 20 tpi CEI and 20 tpi UNF. Both are 60 degree thread angle; the only differences are in the rounding / truncating of the thread peaks, which in real world use disappear once the threads have been assembled a couple of times.
Ian.
1964 Norton Electra
1969 BSA / Suzuki DZR400 / Steib S501
2016 Herald Classic 250

Tigerfeet

I have noted that PES do a 20tpi rotor nut with the note: 5/8 BS Hex 5/8" x 20 tpi late cycle.

This nut will not fit early cycle threads.

https://pesltd.uk/?product=29-2053

I wonder if that is UNF?

I'm not sure if I mentioned that I have three crankshafts - all variously distressed. The best one (from a 1971 engine) has the worst threads....as previously pictured.  This week I bought two rotor nut NOS from Vale Onslow. On the crank with the best threads (which I already have a nut for that goes on and off perfectly) one of the NOS nuts goes on perfectly. And the other locks after 1/4 of a turn...   My suspicion is that V.O. probably muddled different thread form rotor nuts in the same parts bin....  I'm trying to think of a way of working out what thread form is in the naughty nut. But of course it could just be a badly made nut? 


Tigerfeet

Have you tried a thread roller?

Is this a thread roller? I have one of these but due to the shoulder there isn't room to use it.

limeyrob

That does the same job.  It "may" be possible to do some careful reshaping with a hammer and edge pushing the thread over a bit at a time.  I've had to do this on an axle.
Re 20 tpi CEI and 20 tpi UNF, yes they are very similar and I'm certain some UNF nuts are sold as CEI.  I can't remember but one is a slightly tighter fit which may actually be a help in your situation.

iansoady

I note from that link: "This nut will not fit early cycle threads.". Cycle threads whether early or late should all conform to the relevant standard (BS 811:1950). So I don't understand the statement. The whole point of standards is that they describe - well - standards.
Ian.
1964 Norton Electra
1969 BSA / Suzuki DZR400 / Steib S501
2016 Herald Classic 250

limeyrob

Agreed, doesn't make sense.  I wonder if they have mixed up the CEI pitches?  7/16", 1/2", 9/16" and 5/8" CEI come in both 26 and 20 tpi which has confused me in the past.  BSA used the 1/2" x 20 CEI for the A10 camshaft but 1/2" x 26 everywhere else.
https://www.triple-mregister.org/uploads/retro/thread_data.pdf