Wassell Vape Electronic Ignition - Faulty Stator?

[maddogb31]

Hi All,
I recently fitted the Wassell Vape Micro-MK1 to my BSA A50.
It ran OK for the first 100 mile then it became difficult to start and would cut out at junctions etc.
The (new) plugs were a bit sooty on inspection.

I tested the (new) 6v coils at 1.5ohm primary & 9.4k secondary, I could not find any spec in the instructions (except for 12v dual output racing coil) I assume my coils are ok.

However the stator tested 132.5ohm (instructions state 146ohm). Is my stator faulty? Has anyone tested theirs?
I have emailed Wassell but yet to have a reply!

I am currently running on points, 12v coils, nice fat spark, starts easy and no cutting out so confident that ignition was the problem.
TIA Ian

[Allan G]

It would be rare that the stator coils are faulty, check the continuity between the wires also.