Loss of gears

[DAVE BRADY]

Hi Kevin,

It looks like the 'L' which has probably been done by a previous owner is near the wrong hole.  Assuming it is meant to indicate the oil level screw then it should mark the one with the hole rather than a cut out.

Dave.

[Kevin1963]

Hi Dave

yes thought that could be the case with the L but the two cut outs for the oil drain appear as though they are original a Friday afternoon job? cut the wrong one out and then cut the right one and sent on to be used?

[Kevin1963]

Well back in bike and could change up but not down!!

Cover back off and noticed gear selector plate had cracked and was bent slightly( not noticed when I dismantled.

Anyway had a bit of welding done on it and reshaped as best I can. Now changes both ways with no engine running .

New gasket on its way and then we will see?.

I'll post in wanted but going to need new selector plate.

Kev

[Kevin1963]

All back together

Quick run out to butchers and all working as it should!

Thank you for advice and comments

Kev