Weld repair on a10 ally head

[MJM_58SR]

Hi all
Just looking for recommendations on weld repair for my a10 head, got a crack in the bottom fin in the middle, want the spot facing sorted on the head bolt holes too if possible.
Thanks

[idie]

If it were mine,as it is non load bearing I would drill a small hole right at the end of the crack to stop it going further.

[MJM_58SR]

Hi idie
Thanks for the reply
I was thinking if I can't get it welded then that's what I was going to do, but it also needs drilling before welding anyway to stop the crack propagating after.

[cdsdorset]

T&L engineer in Bedford . I use them for all of my cylinder head work. They recently repaired a T140 head for me that the customer had managed to snap off the rocker box locating lug. Beautiful job and Barry will only do what is needed.

[MJM_58SR]

Thank you, I'll give them a call today