Sloper Crank

Started by Mike Farmer, 22 Jun, 2020, 12:25

Previous topic - Next topic
Print
Go Down Pages1
User actions

Mike Farmer

22 Jun, 2020, 12:25
 :) :) :)

Quick question. Is the oil pump worm drive a machined part of the crank or is it removeable.

#Mike 8) 8) 8)

JulianS

#1
22 Jun, 2020, 12:45
I think part of the shaft, where removable the worm is part of the engine pinion.

Mike Farmer

#2
22 Jun, 2020, 16:28
 :) :) :)

That makes sense, thank heavens that I never tried to pull it. :)

Mike 8) 8) 8)

Mike Farmer

#3
23 Jun, 2020, 13:49
 :) :) :)

Going to need Sloper flywheel riveted. Any suggestions or recommendations.

Any advice always welcome.

Mike 8) 8) 8)

mark quinney

#4
24 Jun, 2020, 07:21
Hi Mike
I saw a picture of a crank that Alpha Bearings  had done which had new rivets on it , so possibly they might be able to supply them or do it for you . Worth  a phone call though
Mark

Mike Farmer

#5
24 Jun, 2020, 08:30
 :) :) :) :)

Hi Mark, Thanks for that.

Mike 8) 8) 8)

Mike Farmer

#6
24 Jun, 2020, 19:30
 :) :) :)

Yep Alpha will do it. The bearing is very poorly anyway so they will do it all together.

Mike 8) 8) 8)

Gtt

#7
27 Jun, 2020, 13:22
The worm drive on the sloper is separate,  part of the removable half timing gear on years 1927 to 1929.

From 1930 the worm was part of the crank

Mike Farmer

#8
27 Jun, 2020, 18:42
 :) :) :)

Thank you

Mike 8) 8) 8)
Print
Go Up Pages1
User actions