1972 A650T Thunderbolt Oil leak

Started by Atkinson, 17 Nov, 2026, 13:53

Previous topic - Next topic

Atkinson

Hi all,

I am working on my barn find, after removing the points cover I saw gearbox oil in the bottom. so I have removed the cover and cleaned up the oil, she is leaking very small amount from the gear change return spring.
Is this normal and if not what is the best thing to do to sort this out.
PS I did find that the hole in the casing below my finger was blocked with gasket sealer.
Any help would be great as I have only worked on a triumph Tiger 1968 back in the 90's 

DAVE BRADY

Hi,

There should not be any oil coming through by the spring. The stud that holds it all in place may let some oil up the thread if it has been undone and is loose.  Cleaning the threads and a bit of sealant will cure that.
On your late model, the cup that holds the spring in place will have and eccentric hole to allow for some adjustment of the spring hence the two little notches on the edge to facilitate turning the cup prior to tightening up.
Assuming that every thing worked fine then note the position of these notches for reassembly. Also, mark the spring to indicate the outer side again to be able it to be put it back the same way.
The screw hole should not be full of sealant as it for one of the screws that goes through the outer cover and inner cover to thread in to the case.
Was there a screw missing from this hole when you took the cover off?


Dave.