A65 rebuild

Started by MITCHELL, 30 Sep, 2026, 15:26

Previous topic - Next topic

MITCHELL

Good day all, after a lot of setbacks in on the rebuild again. Just a simple jQuery to start, fitting a new bush into the timing side inner cover is there a preference for which hold the hole in the Bush should line up with?.As always any help will be gratefully recieved. Dave.

MITCHELL

Morning, help again. I can't find any of the assembly circled, and even if I could I can't see where it fits or what it does. If anyone has any photos r any other info I'd be very grateful.Cheers dave.

Superflash

Those part numbers dont look right. What parts manual is that from? Factory manuals are best.

MITCHELL

This is the parts book ,I also found this on a bay, but I still don't recognize it.

DMadigan

Those parts are not in the '62-'65 parts book on ClassicBritishSpares.com. Parts and repair manuals are free for download. Guessing it might have to do with the gearbox speedometer drive.

MITCHELL

Mark at c&d autos doesn't recognize and has never been asked for them so I think I'll just carry on and ignore them. Thanks.

ChrisG

I'm guessing here but is there a hole in the casing between the two cast lugs on the housing? If so, I think the hole in the bush should line up with that so oil can be caught and drip through to the shaft.....?

MITCHELL

Thanks for the suggestion but there is no hole so can't be that.

MITCHELL

Next problem.... I can't remove the four screws to get to the cush drive rubbers, they won't budge tried release oil, sharp shock with the hammer, ground the impact driver bit down to a perfect fit and still they won't budge. Thought before I get the blow lamp out I'll just check that I can't do any damage to it other than burn the rubbers and if replacements are available. Perhaps maybe it might not need inspecting inside, any tips gratefully received. Other thing is the tab washer between the spacer and the centre nut, I can see one tab folds over the nut but where are the other two ment to locate? Cheers dave.

limeyrob

Cush drive screws.  Does it need to come apart?  These last a long time.
Tab washer, I seem to recall the long one goes in a spline and either of the others on the nut flat.

DAVE BRADY

Hi,

As mentioned, the rubbers last a long time but if needed replacements are available. The give away for the need for replacement is usually bits of the rubber squeezing out of the hub indicating that they are going soft and breaking up.  If you can detect any movement they will need replacing.
The long tab on the washer goes in hole in the side of the hub and the other two are folded up against the nut when it is fully tightened.

Dave.

MITCHELL

There's no sign of any bits of debris so I think as you both suggest leave well alone, thanks for the tab info. Indebted to you both, till my next problem cheers, Dave.

limeyrob

Re the tab washer.  Bend the two shorter taps up slightly before you fit it. Then use swan-necks across the nut to squeeze the tab up and onto the nut flat.

MITCHELL