Plodding on with tidying up my A50
New ( later type) oil feed pipes fitted. Must admit quality of replacement not the best and required quite a bit of bending to fit.
WRT the rocker feed pipe, mine is not in the best condition and I can't seem to source one from the usual suppliers. Have thought about making one out of brake piping - I have got flaring tools. Anyone got experience of doing this?
Hi,
Yes, I silver soldered a nipple onto a length of Cupra Nickel. I had to open the nipple slightly for the pipe to fit, overall better material and worked a treat.
Best wishes...
What nipple did you have and use?
I must admit I did flare a bit of brake pipe and it appeared to fit the connector but not tried it with oil yet!
Hi,
I drilled out the copper from the original fitting. From the link below its a 1/8" BSP:
https://www.draganfly.co.uk/index.php/component/hikashop/product/4979-
Best wishes...