:) :) :)
Greetings. I am in somewhat a quandry with fitting clutch cable. Something that I have done on numerous occasions But!!!
Engine is 1962
Hopefully I have attached a couple of pics to help to show what I'm talking about.
Did the early A65's have a straight cable to actuating arm connection via a ferrule in the rear of the casing??Because there is no way that I can fit the Tube (as shown)
So any help or advice would be appreciated.
Mike 8) 8) 8)
The changed the cable in 1962 this service sheet may explain.
(https://i.imgur.com/8ROC4v3m.jpg)
(https://i.imgur.com/Q6zqD0sm.jpg)
:) :) :)
Thank you both very much.
That is how I remember the layout of the parts(which are now on their way to me).
I thought that I might have to enlarge that orifice in order to take the sleeve, but I didn't want to go at it "willy nilly" without some basic info, especially as the bike is my son's
Just as a matter of interest: would it all work if I just used the small ferrule/spacer on to the end of the cable then directly into the rear of the casing. I imagine that's how they were "pre mod"
Again your assistance greatly appreciated
Mike 8)
:) :) :)
Now got all the bits to do the bottom end of clutch cable.. Thanks agen.
Mike 8) 8) 8)