Hi
I have managed to get all the bit together for the straight pull throttle and ignition controls on the handlebars for my W35-7. I have found an Amal document listing the size and position of the handlebar slot. I have tested this on an old set of bars and it all works fine. What I am missing is the correct location for the 9/32" hole where the cables enter the handlebars. My instructions only say "on the outside of a bend is prefereable". Is there anyone who can give me the location of this hole. A picture would be great.
Thanks.
Gidday from N.Z.,
Is this of any relevance? Off my 1929 Sloper, but thought it might be similar to yours:
https://photos.app.goo.gl/DCB9p2X99ujaVyeF7
Let me know if I've messed up the sharing so you can't see it
Cheers, Bevan
Thanks for the prompt reply. Shows exactly what I needed to know.
Lovely bike by the way!
Colin
No worries :)
Here's a photo from a run out a week or two ago.
https://photos.app.goo.gl/P2s7RmSSKsCytvsRA
Cheers, Bevan