Hello all, I am thinking of acquiring a 1954 M33 plunger. I am trying to source a quality side stand as being short would find the bike difficult to get on/off, and raise onto its centre stand. I would be grateful for any suggestions on where to source a side stand, and where the best fixing point might be on the frame. Has anyone gone down this route? Thanks in advance.
Hi, I have a rigid B31 and use a generic bolt on side stand without any problem, available from fleabay
https://www.ebay.co.uk/itm/BSA-triumph-norton-matchless-UNIVERSAL-PROP-SIDE-JIFFY-STAND-1-1-4-FRAME-TUBE/142666425118?_trkparms=aid%3D222007%26algo%3DSIM.MBE%26ao%3D2%26asc%3D49919%26meid%3D9f6056df1e1d4770bbebdef7a174037d%26pid%3D100005%26rk%3D2%26rkt%3D6%26sd%3D173113263962%26itm%3D142666425118&_trksid=p2047675.c100005.m1851
Thank you Chris Goodwin. Did you weld it to the frame to stop it rotating/slipping?
No, Just nipped it up with the two bolts, just watch that you give enough clearance for the drive chain when fitting.
Thanks again. One last question - where on the frame did you fix the side stand?
Regards,
Hi,
A side stand makes a huge difference, mine, on my B33, is as shown in the photograph and is welded on. Trouble is, the centre stand is difficult to pull down, it is a job where I need to weld on an arm of some sort.
Ideal thank you