BSA Owners' Club Workshop Discussions

The BSA Workshop => Twins => Topic started by: Beeza jon on 08 Nov, 2026, 17:56

Title: A10 pushrod alignment Alloy head
Post by: Beeza jon on 08 Nov, 2026, 17:56
Hi chaps. I've been refitting my alloy cylinder head. All going well, until I went to set the tappets...three good, one not so. I know I've got the push rods misaligned even though I used the "comb". So, do any of you have some experiential advice as to the best way to perform the task?
All answers gratefully received.
Title: Re: A10 pushrod alignment Alloy head
Post by: limeyrob on 08 Nov, 2026, 19:57
We all have ideas, but hardly any work. ;D
Here's my tuppence worth and that could be overvaluing it.
File the comb to fit the push rods, a lot don't fit.
Undo all the tappet adjusters.
Elastic band the rods to the comb
Stick the gaskets to the rocket box
Get a long magnetic rod for pulling a pushrod that slips
When you get a rod in hold that rocker up with a band.
And remember, BSA did these in seconds on a production line so how hard can it be.....?
Title: Re: A10 pushrod alignment Alloy head
Post by: iansoady on 09 Nov, 2026, 10:02
Yes, but the bloke doing it did it day in day out for years. Personally although I didn't have my A10 long (foolishly sold it on) I found the comb didn't help much at all. I seem to remember a good way was to keep the rocker box lifted by 3/8" or so, resting on a couple of bits of dowel. It was then fairly easy to wamgle the pushrods into place with a hooked wire through the gap between head & rocker box and locate the upper ends in the rocker balls. Then carefully lower the rocker box into position.
Title: Re: A10 pushrod alignment Alloy head
Post by: idie on 09 Nov, 2026, 11:19
That's how I did mine
Title: Re: A10 pushrod alignment Alloy head
Post by: Beeza jon on 13 Nov, 2026, 20:20
Thanks for your input chaps, much appreciated. I'll hopefully get things sorted out this weekend. Kind regards Jon.