For the full width hub back brake 1963/1964/1965.
Can someone post photos of the point where the short and long brake rods are joined by the little toggle plate, to include the bracket on the frame?
Thanks in advance.
Hi Julian
I have a couple of pics but am too old and incapable of getting them on the forum! If you could let me have an e-mail address I can send them.
Cheers,
Thanks very much, I have sent you a PM
Julian
Thanks Old Biker, photos arrived and very helpful.
Are these any good?
Better quality on request. Be quick though, bike coming to bits soon.
Kevin
Thanks very useful photos.
They do exist!
Some people don't realise this was a set up!
If you would like some measurements, I will be stripping the frame for blasting and repainting in the not so distant future. Well, when the engine had been decided on!
Kevin
Just one dimension - is the long rod 5/16 diameter, same as the short front rod?
Thanks
I work away from home. I will be back home tomorrow night and taking the bottom end out of the bike on Saturday morning. Will measure it for you then!
Hope this is ok?
Kevin
Whenever you can, no rush.
Thanks.