Print Page - Con rod & Big/Little end assy wanted

Title: Con rod & Big/Little end assy wanted
Post by: PaulG on 21 Nov, 2021, 05:51

Hi All,

Where could I buy a new con rod assembly for my '53 D1 ?

The gudgeon pin I have in my new piston (re-bore) is 12mm. The old one in the damaged piston was also 12mm.
Apparently some early D1's had a smaller gudgeon pin.

The big end pin that I pressed out of the flywheel is 19mm (or 3/4")

See photo.

Thanks in anticipation,
Paul G

Title: Re: Con rod & Big/Little end assy wanted
Post by: AdrianS on 21 Nov, 2021, 22:35

Have you tried Rex Caunt ?

Title: Re: Con rod & Big/Little end assy wanted
Post by: bluebell on 27 Nov, 2021, 04:24

do you have an adjustable reamer? is your big end good as i may have a new small end in my bits chris 07901735443 swansea

BSA Owners' Club Workshop Discussions

The BSA Workshop => Bantam - pre 1973 => Topic started by: PaulG on 21 Nov, 2021, 05:51