I have rebuilt my BSA A10, rewired, designing the loom and added LED Indicators and hazzard warning lights on a new circuit. I can tend to leave indicators on when riding and often don't hear the buzzer. Most indicator warning lights come off the third connector of the relay but I want left and right separate warning lights. I have tried to take them off of the left and right front indicator feed wires but although the LED warning light works, it will not light when power is supplied to the indicators. I am simply attaching the live to the power supply and earthing the earth but have also tried piggybacking both wires from the live (as the LED is a diode) but neither work.
Any hints?
Can you get a twin pole- change over relay, and run the indicators off one side and the warning lights off the other?
Regards,
Dave.
P.S. Good luck. I'll be interested in whatever the correct solution might be, for my A65 indicator circuit. (I'm prone to forgetting that I indicated to turn left or right... twenty miles ago....)
Gerald
If it helps, if All the components are LED (my error) flasher, indicators and warning light, just take the warning light off the L & R connectors. i.e. one connector for power in from switch, front and back indicators for one side and warning light. Obviously, same for the other side. I have got the indicators and hazards running off the same circuit, the only issue is rather than a hazard warning light you get both indicators flashing.
I can supply a simple wiring diagram id you want it?
:) :) :)
Not very helpful I'm afraid but have you considered polarity.
Mike 8) 8) 8)