Hi all , recently bought an oil pump for
A project engine , standard cases, supposed standard
Pump , but as you can see from the photo
The third screwe hole is about 10mm away from
Pump boss , any ideas?
Does not look like an A10 pump. Could be an A65 one.
A10 pump photo below.
The steel tube visible would suggest the lubrication system has bee modified.
Hi yes I'm doing the oil mods, I dont think it's off an a10 ,
But am in the dark as what it could be off , the mid cover will not fit either, not a65 no webbing to the third mount !
Early A65 pump no webbing.
Yes that might explain it , 62 etched on pump and feed port
On pump has chamfer as the a65 have the anti drain bearing
Directly under the pump , nice one thanks .