Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tomlinson

Pages: [1]
1
Pre War / Top yolk girder fork
« on: 22 July, 2022, 16:02:20 »
I have a top yolk with a cotter pin instead of a pinch bolt.Any ideas which model it’s off.Going onto a B26.🛠👍

2
Pre War / Conrod
« on: 23 February, 2022, 20:38:43 »
Anyone got a conrod to sell 65-464?

3
Bantam / Bantam rear wheel
« on: 20 February, 2022, 18:44:45 »
I have. B26...1937.No back wheel.
I have seen I can fit a Bantam half width hub.
Anyone got a 18” for sale?

4
Singles / B26 1937
« on: 15 February, 2022, 12:46:53 »
Anyone got a conrod/crank pin/Rod is 65-464. I can clean it up if it is rough.Alsoany wheels for b21/26.
Thanks Dave in Bristol

5
Pre War / B26 Clutch sleeve
« on: 18 November, 2021, 08:30:08 »
I am having trouble finding a clutch sleeve that fits the main shaft on a handchange box.The taper is too far out in a sleeve I have and is sloppy.Part number is listed as 65-3832.Does anyone know if a c type can be modified.
I have a six spring Bgroup  later clutch to try to fit to it.
Dave

6
Pre War / B24 clutch
« on: 08 November, 2021, 21:12:48 »
I have a prewar gearbox 1938 handchange .I also have a six spring BGroup clutch.Does anyone know of an adaptor for the taper?

7
Pre War / B24 Clutch type/piston type flywheels
« on: 06 October, 2021, 21:13:02 »
Has anyone used a different clutch to the single spring type? I also have a domed piston and a flat top one.Which is right for a B24 Tourer? I also have 2 sets of flywheels.the thickness of the actual flywheels are different.Does that matter?
Dave

8
Pre War / B24 1938
« on: 05 October, 2021, 18:40:47 »
I have just acquired a B24 frame and an old engine JB26.196.I think it is a 350cc.I need a big end /pin,piston,carb,magneto,dynamo ,pushrod tube ,clutch,fork pins, and lots of other bits.I have a couple of gearboxes but don’t know what type  they are yet.Any old bits welcome to use as patterns.
Wheels seem to be rare.Can I fit bantam wheels until I get originals?
And loads of advice.
Based Bristol.
Dave T. 21 Triumph,MG,Morgan,Landy.

Pages: [1]