Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - malzstx

Pages: [1]
Twins / Front wheel removal
« on: 29 March, 2018, 16:58:16 »
I am attempting to remove the front wheel of my Super Rocket. I have slackened the pinch bolt and the spindle has a round machined end with a hole through it. I have had a toggle bar in but can barely move it. My question is, is it a left hand thread on the spindle??
                                                                                                                                Many Thanks, Malcolm

Twins / Speedo bush seal
« on: 12 March, 2018, 16:35:49 »
Can anyone out there tell me where I could purchase a SQUARE SECTION round oil seal which fits into the speedo bush of my Super Rocket? Thank You. Malcolm.

Twins / Rocker box studs
« on: 17 November, 2017, 15:05:16 »
Help please.....I have removed the cast head off my super Rocket and replaced it with a 67-1549 alloy head. On the cast head, the 4 corner studs on my rocker box pass through the cast head and tighten the nuts from underneath. However, when I offer up the rocker box to the alloy head, they are 2ins short and not long enough to pass through the alloy head. Is there anywhere I can purchase the longer studs or advice please? Many Thanks....Malcolm.

Twins / Torque Settings
« on: 10 November, 2017, 16:23:42 »
Hi Guys.....can anyone tell me the torque settings for the alloy head of my 1959 Super Rocket and do I need to use thick washers on the head bolts......thanks

Twins / Breather dripping oil when running
« on: 17 August, 2017, 17:24:45 »
Can anyone tell me why I am getting drips of oil from the breather when the engine is running on my Super Rocket?.....thanks.

Twins / Carburation
« on: 09 August, 2017, 14:59:15 »
Apologies firstly....this is not to do with my Super Rocket but my 1960 T120 Bonneville. The bike runs and ticks over very well, however, I have noticed that the left exhaust pipe and silencer is only warm, whereas, the right side is running hot. Can anyone on the forum give me any idea of the problem? both cylinders are firing very well! Thanks in anticipation.....Malcolm.

Twins / Zinc/alloy speedo drive bush .
« on: 01 June, 2017, 16:47:46 »
For information of Julian and all other members.... the 'square section' oil seal from the zinc/alloy speedo drive bush for A10/7 etc. is available from BRITISHBIKEDOCTOR on Ebay and part listed as ;Triumph 57-0948 priced at 2.88p.

Twins / Speedo oil seal
« on: 29 May, 2017, 14:04:28 »
Hello there anyone out there can help me source the oil seal which is fitted to the alloy speedo pin located in the lower front of my Super Rocket gearbox to which the speedo cable couples onto. Many Thanks, Malcolm.

Twins / Speedo drive into gearbox
« on: 20 March, 2017, 18:36:48 »
The speedo drive cable of my Super Rocket screws into what appears to be a threaded nipple at the base of the gearbox and it looks like I have a slight oil leak from the nipple. My question is; is this nipple screwed into the front cover or is it part of the casting? the nipple has no flats to tighten it with a spanner, but is ROUND and won't move with a pair of water pump pliers. Thanks in anticipation....Malcolm.

Pages: [1]