Hi, can anyone help with this one?
I bought a new loom and it has sockets for the lighting and ignition that go into pins on the back of the switches. My switches are not like that - the wires connect directly to the switches. The light switch seemed to marry up quite well but the old ign switch has 6 wires connected to it with connections as follows
12 brown/white ammeter
13 purple to rectifier
14 white neg side of coil
15 black/white pos side of coil
16 green/yellow alternator
18 brown/white number 5 pin on light switch
The new loom has only 5 connections to the socket
12A brown/W to rectifier and ammeter
13 W to coil -
15 black/W to coil +
17 G/Y to alternator
18 black to pin 5 light switch
Confusing matters further is the fact that I have fitted a rectifier/regulator
Can my old ign switch be made to work with this lot. If anyone has done this and can post a wiring diagram I would be most grateful
Cheers,
Phil