Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Gtt

Pages: [1]
1
Pre War / Re: BSA 350cc OH sloper 1930 Cylinder base shim
« on: 16 January, 2018, 01:27:17 »
I have a 29 350cc sloper with high comp piston . Spacer is 1/16 inch  approx 1.67 mm thick

regards

Greg

2
Pre War / BSA 350 sloper Crank pin bearing cage
« on: 13 December, 2017, 09:47:10 »
HI

I am looking for a crank pin cage for a  1929 350 sloper . Has to suit two rows of rollers 1/4 dia by 5/16 , 24 in total
crank pin is 1 1/8, con rod big end  1 5/8.


cheers



3
Pre War / Sloper Magneto base plate
« on: 24 November, 2017, 12:14:56 »
Hello

I am missing the base plate for a 1929 BSA sloper that sits under the magdyno. I am not sure if someone has one loose they could scan on their printer and send to me and I may be able to have one made? Alternatively I might be able to figure it out if I have the material thickness

regards

Greg

5
Singles / Re: 1929 350cc sloper
« on: 22 October, 2017, 11:14:26 »
Hi Julian,

You wouldnt be able to dropbox the 1929 manuals etc? I haven't been able to find in the vintage  club library.

regards

Greg

6
Singles / Re: 1929 350cc sloper
« on: 21 October, 2017, 02:45:28 »
Thanks Julian

The upright tube under the seat is definitely different. The forks and brake lighter also. I cannot make out whether the horizontal tube has the cut out like the 500 version.

Greg

7
Singles / 1929 350cc sloper
« on: 20 October, 2017, 00:44:15 »
Hi,
I recently acquired a d series 350 cc sloper engine is quite good condition. I am interested to know if the frame is the same as the 500? The barrel and head appears a inch shorter so I am not sure if it requires the bend in the horizontal tube above the engine. I am looking for drawings of the frame if available

Any other differences of note between the 350 and 500? I understand the 350 were less common.

Cheers

Pages: [1]