Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DEDGE

Pages: [1]
1
Singles / !950 b31 petrol tank
« on: 12 January, 2018, 15:33:23 »
Hi Guys
I need some advice about the petrol tank that come on my bike ,the frame is a 1949 plunger. Is it the right tank if it isnít what is the difference.  As I am trying to fit a solo saddle I thought I had better check that the tank is ok size wise and shape etc.
All The best
Dedge

2
Singles / 1950 B31 Saddle
« on: 04 January, 2018, 16:57:07 »
Hi Guys
I am rebuilding a 1950 plunger B31, and want to fit a solo saddle. I have brought a wasselll one from Dragonfly (large lycett type) but when you offer it up with the springs on it appears to be the right width but to long (about 14inches) to fit the cutaway in the tank properly. Has anyone got any pictures or measurements of the correct one or has anybody fitted an after market one

Thanks
Dedge

3
Singles / B31 stand spring
« on: 21 October, 2017, 15:16:36 »
Hi Guys
I have just brought a new spring for the main stand the dealer assured me it was the right one (it was different to the one I took off)

Can you tell me which way round it goes hopefully I have attached a picture.

it is on a 1950 B31 plunger frame

Best regards Dedge

4
Singles / 1950 b31 plunger info
« on: 17 September, 2017, 16:24:58 »
Hi Guys
Can anyone give me some technical advice please? I have a 1950 B31 which I am trying to renovate. I brought a rear brake rod complete at the weekend but when I got home and checked it is was longer than the old which is 20 inches overall. Can anyone the correct length please.

Best regards
Dedge

5
Singles / B31 help
« on: 28 July, 2017, 15:20:50 »
Hi Guys
Can anyone give me some technical advice please? I have a 1950 B31 which I am trying to renovate and started to take the engine apart. Taking of the cylinder head there was a thick head gasket, I did not think there was one, can you tell me if they are the right parts. Iron head and cylinder casting No on head66-1157, casting No on cylinder 65-1703 or could be 66-1793 or the 66 could be 65. And worst news on the inside of the cylinder liner, timing side and 2 deep groves about the width of the gudgeon diameter I take these are not meant to be there. I f the liner is gone can theses still be got or repaired. I live in Dorset
Best Regards
Dedge

6
Singles / 1949 b31 plunger frame info
« on: 13 February, 2017, 16:52:52 »
Hi All
I have a 1949 b31 plunger frame bike I have stripped for renovation. On the front half of the main frame is the rear down tube at right angles to the main top cross bar. The front down tube also looks like in may be bent. Could anyone recommend a frame repairers, near to were I live which is Swanage in Dorset   
Thanks
Dedge

7
Hi
If anyone went to the classic bike show at the weekend. In the first hall on the left as you went in the gate, at the top end was a stand with bare metal chain cases, chain guards and a single saddle frame. I forgot to get some contact details, the organisers have told me the stand was let to a Derek Huyton but were not allowed to give me his details. I am interested in his stuff if anyone has any contact details.

Thank you
Derek Evans

Pages: [1]