Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ROYC

Pages: [1] 2
1
Twins / Oil feed routing
« on: 27 March, 2017, 14:19:21 »
I have looked for a routing diagram, without success.
Does anone know which side of the bottom oil tank fixing does the rocker box feed go ?
When I got the bike it was routed on the engine side of the bottom fixing, I think it would look much better if it was routed between the bottom fixing and the frame.
Is there any reason why I can't do this ?

Picture shows it routed on the engine side of the bottom fixing.

2
Twins / Nut removal
« on: 25 March, 2017, 21:28:17 »
I am trying to remove the acorn nut from the end of the rocker shaft but the shaft just turns and the nut stays put.
Any one got a trick to lock the shaft so that the nut can be removed ?

3
Twins / Screw size please
« on: 17 March, 2017, 15:49:20 »
Does anyone know what size the screws are that hold on the rubber knee pads ?



4
Twins / primary chain case cover
« on: 09 March, 2017, 18:54:35 »
Does anyone know if my 1958 primary chain case cover with just the one cap will change for the newer type with the two caps and the drain / level plug in the bottom ?


5
The Star and Garter / 6v to 12v
« on: 03 March, 2017, 08:06:22 »
I am going over to 12v.
Do I have to change to a 12v horn or will my 6v horn stand the pressure ?

6
The Star and Garter / Spark plugs
« on: 27 February, 2017, 20:30:47 »
Is Champion N4 the same as N4c ?

My bike is a 1958 A7SS.

7
The Star and Garter / Light bulbs
« on: 23 February, 2017, 11:52:20 »
Are there any direct replacement LED's for the standard tail/stop bulb and the pilot bulb in the headlight. Also a direct replacement Halogen 12v for the headlight.
I am thinking of going over to 12v useing an electronic control box, DVr2.
http://www.dynamoregulators.com/dvr2.php

Thanks
Roy

8
Twins / Position of controle box
« on: 19 February, 2017, 19:58:51 »
1958 A7 ss.
On my BSA the control box is fitted in the tool box, I can't remember it being here on my 1961 bike.
Is this where it was originally fitted ?

9
Twins / headlamp cover acorn nuts
« on: 19 February, 2017, 10:18:38 »
Has anyone got any idea where I can get the two acorn nuts that are just under the headlight on the cover (preferably stainless)


10
Twins / A7 SS Colour reminder
« on: 18 February, 2017, 22:07:09 »
On the old forum someone told me of a colour used on a Jap car that was a good
Match for the A7 Shooting Star.
I have tried to access the old forum but no joy.
Can someone refresh my memory please ?
Thanks
Roy

11
Twins / Oil Level
« on: 17 February, 2017, 18:48:40 »
In my handbook it shows the primary chain case with a filler hole, a clutch adjusting hole and a drain/oil level hole at the bottom.

My chain case only has a filler hole (see picture).
How do I know when I have the correct oil level.

My engine number is CA7SS 5593



12
Twins / Lubricants
« on: 15 February, 2017, 19:42:22 »
I am in the process of ordering engine oil, fork oil & grease.
Unfortunately the lubricants in the hand book are not easily obtained.
What oils do other members use in their BSA's?

1958 SS

13
The Star and Garter / Thread gauges
« on: 13 February, 2017, 19:42:11 »
I want to order a set of thread gauges to use on my 1958 BSA.
What threads are used on BSA's ?

14
Twins / Refurbish old brake plate
« on: 13 February, 2017, 12:49:47 »
8 inch full width.
When I think back to the early 60's.
The brake plate had a chrome edge to it, sadly these are no longer available new, so will they polish up or better still will they chrome ?





15
Twins / Brake plate removal
« on: 13 February, 2017, 10:01:50 »
Hi all,
(8 inch full width)
I am trying to remove the brake plate and hub cover.
I have removed the nut & washer from the brake plate but it won't lift off.
On the other side of the drum, I have removed the circlip but every thing is just as tight and the cover plate won't move.
How do you take this drum apart?


Pages: [1] 2