Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - DOIVEY

Pages: [1]
Singles / Re: c11g wiring help
« on: 27 September, 2017, 22:31:24 »
check out the link below
scroll down a bit to sheet 808C contd.

should point you in the right direction.

make sure you have the correct c11g electrical parts fitted otherwise it could get confusing if there are bits from other bikes there with different connections etc...

good luck.


Which BSA do you ride? / Re: b26 hello just arrived
« on: 20 August, 2017, 21:58:41 »
Hi Nigel,

you'll find most parts including some engine parts are applicable from the B20 right thru to the B26.

Don't get hung up on parts not being the correct number for your Bike.

You'll probably find its the same part with different number stamped on it .

I've have found this restoring my B20. 

I wish there was a big database cross referencing parts numbers across the different models for what the same parts were used.

Good Luck

Pre War / Re: B21 tappet Clearances
« on: 26 July, 2017, 19:10:03 »
Thanks Julian, much appreciated.

Pre War / B21 tappet Clearances
« on: 24 July, 2017, 21:44:59 »
Can anyone in the know enlighten me as to what the clearances are for the inlet and outlet on the B21 please.
when i rebuilt the engine i set them by rotating the pushrods without resistance and making sure they didn't rattle vertically.
i just wondered what the correct values are.
thanks in advance

Pages: [1]