Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JOHN KAY

Pages: [1]
1
Twins / Re: A65 swingarm bush removal
« on: 10 November, 2017, 15:05:50 »
hi there,
what I do is burn out the rubber using a small blow torch then the inners  just pull out but to remove the outers what I do
is use a hacksaw blade lengthwise and cut a slot in the bush but not all the way thro then collapse it using a sharp punch
until you can get a small chisel or similar in works for me . regards john kay .

2
Twins / Re: Electronic ignition
« on: 09 April, 2017, 17:54:04 »
HI there

I HAVE AN UNUSED BOYER MARK 3 ELECTRONIC IGNITION FOR A65 IF YOU ARE INTERESTED
PRICE IS 65 PLUS POST MY EMAIL IS john.kay50@yahoo.co.uk REGARDS JOHNBOY >

3
Twins / Re: A65 rebuild
« on: 03 April, 2017, 12:28:51 »
HI THERE
I FITTED SWINGING ARM BUSHES MYSELF WITH GREAT DIFFICULTY AS THEY ARE USUALLY VERY TIGHT TO GO IN >
I USED A LENGTH OF HALF INCH OR SIMILAR SCREWED ROD AND NUTS USING SOCKETS AND LARGE WASHERS TO FIT
AND PULLED THEM IN SIMILAR TO HOW YOU WOULD FIT SMALL END BUSHES > A LITTLE TIP IS TO SMOOTH DOWN
THE ROUGH FINISH OF THE BUSHES WITH A STRIP OF EMERY  AND USE OIL ON BOTH SURFACES  TO EASE THINGS
A LITTLE > REMEMBER TO REMOVE ANY POWDER COATING ON THE INSIDE OF THE SWINGING ARM BUSH HOLE >
IT CAN BE DONE REGARDS JOHNBOY .

4
Which BSA do you ride? / johnboys recent purchase b25 1970
« on: 23 March, 2017, 11:22:16 »
HI GUYS HOPEFULLY A PHOTO COMES OF MY RECENT PURCHASE A 1970 BSA B25 needing engine work regards JOHN

Pages: [1]