Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jackson

Pages: [1]
1
Twins / Useful A10 valve info.
« on: 22 January, 2018, 15:25:32 »
You may all know about this already, but in case you didnít.
Iíve just bought new inlet and exhaust valves (53 plunger A10) and they appear to be the same size and arenít marked in any way☹️
Just found out how to tell them apart. The exhaust valves are Austenitic steel and non magnetic. The inlet valves are magnetic. Saved me a lot of trouble.

2
Twins / A10 Pistons again
« on: 04 January, 2018, 16:30:28 »
Sadly, I can't get away with using my existing (+060") pistons and now have to reline the barrels and get new pistons for my '53 Flash.
I realise that the lowest compression I can get is 7.25:1, but these mostly seem to be new Hepolite which I hear bad reports of (or at least the rings).
IMD are available complete with new liners, they say they are 5g lighter than the original, won't this mean I have to rebalance the crankshaft?
I would value any thoughts on good pistons and where to get them.
Thanks in advance,
 Adrian

3
Twins / Clutch Centre Nut
« on: 16 November, 2017, 16:26:28 »
I am having real problems removing the clutch centre nut on a 53 plunger A10.
Am I doing anything stupid? Iíve bent the tab washer back.
Itís not a left hand thread is it?
Adrian.

4
Twins / A10 Pistons
« on: 01 November, 2017, 14:38:26 »
Looking around the web, the lowest compression pistons I can find for the A10 (53 plunger) are 7.25:1. I believe the correct pistons for a GF are 6.5:1.
Does anyone have any comments about the advisability of using the higher compression pistons? They are flat, the lower compression ones are dished.
Any thoughts would be valued.
Adrian

5
Twins / Plunger A10 Front Wheel
« on: 15 August, 2017, 20:16:42 »
I have just taken the wheel (what appears to be a normal 8" half width) off and there is a collection of 3 washers or spacers on the LHS, a single washer on the RHS and the spindle has no step in it.
 This looks odd to me. Were there any like this or am I looking at a bodge?
I think my safest option is to get a new spindle and bearings and replace them. Everything else looks OK.
I'd appreciate any thoughts with thanks.
Adrian

6
Twins / Plunger A10 pinch bolts
« on: 11 August, 2017, 09:54:19 »
HI,
I've just started working on my new (to me) '53 plunger A10, getting it ready for the road. I've found that instead of the lower rear plunger pinch bolts I have metric bolts with an odd collection of washers and spring washers. I was going to get replacement pinch bolts (with a flattened collar) but can't find any. Does anyone have the dimension (length, diameter, diameter and width of collar, and thread - I expect 26 tpi) to enable me to make them please?
I think I may have many more questions like this , as when I took the front wheel out a collection of 4 washers dropped out?!?  :)
Thanks in advance for any help.
Adrian

Pages: [1]