Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tonyairconchap

Pages: [1]
1
Pre War / Re: Sloper wiring info advice please
« on: 15 October, 2017, 09:27:31 »
Hi Bevan, thanks for the offer, i have a wiring diagram but it does not give the length of the cables under the tank panel.
should they be long enough to remove the panel?
How long shoud the inspection lamp wiring be?
To remove the tank i will need to disconnect the cables, could i install a connector block to make it easier....anyone else done this?
kind regards
tony

2
Pre War / Re: BSA M34 -12 ADVICE AND HELP PLEASE
« on: 14 October, 2017, 09:31:17 »
Contacted the GPO vehicle owners club...my bikes not GPO.
someone must of just liked red over the history of the bike.
will keep it as it is as its different

3
Pre War / Sloper wiring info advice please
« on: 14 October, 2017, 07:07:45 »
Hi Team, would anyone be able to give me any help on wiring on a 1934 sidevalve.
my bike has the instruments in the tank panel.  How long, extra slack should i have in the panel to make it possible to lift off the instrument panel to wire / work on it?
How long should the inspection lamp wires be?
has anyone ever fitted a connector under the tank to act as a quick disconnect of the wiring loom for when the petrol tank is removed?
look forward to any replies that could assist me please
thanks
tony

4
Pre War / Re: BSA M34 -12 ADVICE AND HELP PLEASE
« on: 24 September, 2017, 22:15:22 »
Thanks mike,  i will see if i can contact them.
cheers tony

5
Pre War / Re: BSA M34 -12 ADVICE AND HELP PLEASE
« on: 23 September, 2017, 22:04:15 »
Hi , another question, might sound daft but  sure there is an easy answer.
i want to remove the panel with the instruments in the tank, disconneted the oil line etc but found that the wiring loom is too short to pull panel away from the tank.
should the cabling be longer ? Or is it that i need to remove the loom from the headlight?
if its that the cabling is too short i will run new longer cables on rebuild.
how long should the inspection lamp cables be?
cheers
tony

6
Pre War / BSA M34 -12 ADVICE AND HELP PLEASE
« on: 23 September, 2017, 20:28:32 »
Hi all, Newbie so treat me well please.
i have just purchased a BSA M34-12   1934    and would like to ask if any of you good folk could answer a few questions.
1) where can i get a technical service manual..had a search on the net and had no joy.
2) my bike has red wheels and red panels on the tank.....could it be Ex Post Office? Any way of checking......or is it that someone just liked red!  ( its like the telegram bantam red)
3) Anyone recommend a reliable  repairer of magneto and speedo.
look forward to your replies
tony

Pages: [1]